Brother CP-2000 Kullanıcı Kılavuzu - Sayfa 16

Yazılım Brother CP-2000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Brother CP-2000 33 sayfaları. Copyboard
Ayrıca Brother CP-2000 için: Kullanıcı Kılavuzu (19 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Parça Referans Listesi (18 sayfalar)

2. Setup

Partition mounting

Follow the precautions below to mount the copyboard correctly on the partition

and reduce the risk of it falling down.

Before attempting to hang your copyboard on a cubicle wall, partition, or the like

("partition"), consult the manufacturer of the partition to verify that the partition

is capable of supporting the copyboard without adverse consequences.

The enclosed partition-mounting brackets allow you to hang the copyboard on a

standing partition 1.5 in. to 4 in. (38 mm to 102 mm) thick and sturdy enough to

withstand a weight of at least 77.3 lbs. (35 kg).

Do not install, adjust, or remove the partition-mounting brackets with the copyboard

hanging from the wall-mounting bar. Always remove the copyboard beforehand.

Attach the two fixed parts of the partition-mounting brackets to the wall-

mounting bar with the four enclosed screws.

Insert the ends of the movable parts of the

partition-mounting brackets into the fixed parts.

While holding the partition-mounting brackets

clamped around the top of the partition, tighten

the knobs.

Attach the two wall-mounting brackets to the back of the copyboard as

described in step

Either end of the movable part of the bracket

can be used depending on the width of the

partition. Insert the end stamped A if the

partition is 1.5 in. to 2.8 in. (38 mm to 71 mm).

Insert the end stamped B if the partition is 2.7

in. to 4 in. (69 mm to 102 mm).

of Mounting the copyboard on page 11.