AEG ARCTIS Kullanım Talimatları Kılavuzu - Sayfa 34

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured

in accordance with the appropriate standards. The necessary measures

in accordance with appliance safety legislation regulations (GSG), acci-

dent prevention regulations for refrigeration appliances (VBG 20) and

the regulations of the German Society of Electrical Engineers (VDE)

were observed in the manufacture of this appliance.

The refrigerant circuit has been checked for leaks.

;

This appliance is in accordance with the following EU guidelines:

– 73/23/EWG dated 19 February 1973 - low voltage guidelines.

– 89/336/EWG dated 3 May 1989

(including guideline change notice 92/31/EWG) - EMV guideline

• Refrigerant

Fluids, which are used for refrigeration are called refrigerants. They

have a relatively low boiling point; so low, that the warmth of foods

in the refrigeration appliance can cause them to boil or vaporise.

• Refrigerant circuit

Sealed circulation system, in which the refrigerant is found. The refri-

gerant circuit consists for the most part of an evaporator, a compres-

sor, a condenser and tubing.

• Evaporator

The refrigerant is evaporated in the evaporator. This warmth is with-

drawn from the appliance interior, which is thus cooled. Like all

fluids, refrigerants require warmth in order to be evaporated. For this

reason the evaporator is located in the appliance interior.

• Compressor

The compressor looks like a small bin. It is powered by an electric

motor and is housed at the back in the base of the appliance. It is the

task of the compressor to withdraw vaporous refrigerant from the

evaporator, to compress it and feed it to the condenser.

• Condenser

The condenser is usually in the form of a grid. Compressed refrigerant

from the compressor is liquefied in the condenser. Thus warmth is

released, which is given off into the surrounding air at the surface of

the condenser. The condenser is therefore outside of the appliance,

usually at the back.