Brother HL-730 Hızlı Kurulum Kılavuzu - Sayfa 14

Yazılım Brother HL-730 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Brother HL-730 17 sayfaları. Quick setup guide - english
Ayrıca Brother HL-730 için: Kullanım Kılavuzu (25 sayfalar)

Sayfayı Yazdır

English: HL-YL Quick Setup Guide, Body

Additionally, there are four sub-menus as shown in the table below. Select a sub-menu by

clicking the desired sub-menu with the mouse, by using the cursor key and the Enter key, or

by using the keys shown below to switch the screen to the sub menus.

Direct Access

Printer Setup

Console Config Alt + C

Guide

Help

Using the Printer Status Monitor Program

Type C:\RPCX>STMX and press the Enter key to make the Printer Status Monitor Program

stay resident in your computer memory. If there are any changes to the printer status, it

displays a message on your computer screen.

If the printer status monitor program stays resident in your computer, you can monitor the

printer status on your computer screen immediately using the hot-key sequence (Ctrl+Alt+R).

To remove the Printer Status Monitor program from your computer memory, type

C:\RPCX>STMX/R and press the Enter key.

The RPC works in the environment where your printer is directly connected to your

computer. If you are using any printer buffer switches which do not support bi-directional

communication between the printer and computer, the program works only in the PC to

printer direction and cannot receive printer status information.

The program does not work with printers on a network.

If the RPC conflicts with some application software, exit your application software and

then run the RPC.

The RPC may work in the DOS-compatible box screen mode of Windows, however, it is

recommended that you completely exit from Windows to the DOS prompt before using

the RPC.

The Printer Status Monitor and some other Terminate-and-Stay programs cannot coexist in

the computer's memory. If they do not work properly together, use them one at a time.

You can suspend the Printer Status monitor with any of the following methods or

commands.

Type C:\RPCX>STMX/R and press the Enter key.

Hold the space bar down while executing the AUTOEXEC.BAT file at DOS startup to

prevent the status monitor being loaded as a TSR program.

Press the keys Functions

Alt + D

You can directly control printer functions such as Print

Form, Self Print, Reset Printer, Sleep Control.

Alt + P

You can enter the setting mode to change further

printer settings, such as, margin settings, continue

mode, reprint function, font, and sleep mode.

You can change the environment settings for the RPC

program: color, Status Monitor configuration, etc.

Alt + G

You can get into the Guide mode.

You can get on-line help about the current highlighted

item by pressing F1.