For Wireless Network Users
One push setup using WPS (Wi-Fi Protected Setup) or AOSS™
(Windows
19
Configure the wireless
settings
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your wireless access point/router.
If you began the wireless setup from step 5 on
page 7, press WPS/AOSS.
Then go to d.
All other users, go to c.
c
On your machine, press Menu.
Press a or b to display Network, and press
Network.
Press WLAN, and then WPS/AOSS.
d
When WLAN Enable? is displayed, press On.
This will start the wireless setup wizard.
Otherwise press Stop/Exit to exit from the
wireless setup wizard.
e
When Start WPS or AOSS on your
wireless access point / router ,
then press OK. appears, press the WPS or
AOSS™ button on your wireless access
point/router. See the user's guide for your
wireless access point/router for instructions.
And then press OK.
This feature will automatically detect which
mode (WPS or AOSS™) your wireless access
point/router uses to configure your machine.
30
®
and Macintosh)
Note
If your wireless access point/router supports WPS
(PIN Method) and you want to configure your
machine using the PIN (Personal Identification
Number) Method, see Configuration using the
PIN Method of WPS (Wi-Fi Protected Setup) in
the Network User's Guide.
f
A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
Troubleshooting on page 31.
Wireless setup is now complete. A four
level indicator at the top right of your
machine's LCD will show the wireless
signal strength of your wireless access
point/router.
To install the MFL-Pro Suite, continue to
step 20.
®
For Windows
Users:
Now go to
page 35
For Macintosh Users:
Now go to
page 37
Sayfayı Yazdır