Brother MFC-J430w Kullanıcı Kılavuzu - Sayfa 28

Yazılım Brother MFC-J430w için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Brother MFC-J430w 41 sayfaları. Product safety guide - spanish
Ayrıca Brother MFC-J430w için: Gelişmiş Kullanıcı Kılavuzu (47 sayfalar), Manuel (12 sayfalar), Manuel (21 sayfalar), Ürün Güvenlik Kılavuzu (17 sayfalar), Hızlı Kurulum Kılavuzu (37 sayfalar), Güvenlik Kılavuzu (17 sayfalar), Hızlı Kurulum Kılavuzu (37 sayfalar), Hızlı Başlangıç Kılavuzu (37 sayfalar), Hızlı Başlangıç Kılavuzu (22 sayfalar), Kullanıcı Kılavuzu (40 sayfalar), (İspanyolca) El Kitabı (21 sayfalar), (İspanyolca) El Kitabı (16 sayfalar)

Sayfayı Yazdır
Brother MFC-J430w Kullanıcı Kılavuzu
Chapter 7
d
Press a or b to choose Page Layout.
Press OK.
e
Press a or b to choose 2in1(ID).
Press OK.
f
Press Mono Start or Colour Start.
The machine starts scanning the first
page.
g
After the machine has scanned one
side, press 1. Turn over the
identification card and press OK to scan
the other side.
Note
• Sort and Enlarge/Reduce are not
available with 2in1(ID).
• If you are producing multiple colour
copies, 2 in 1 (ID) copy is not available.

Sorting copies using the ADF

You can sort multiple copies. Pages will be
stacked in the order 321, 321, 321, and so on.
a
Press
b
Load your document.
c
Enter the number of copies you want.
d
Press a or b to choose Stack/Sort.
Press OK.
e
Press a or b to choose Sort.
Press OK.
f
If you do not want to change additional
settings, press Mono Start or
Colour Start.
Note
Fit to Page and Page Layout are
not available with Sort.
24
(COPY).

Adjusting Density

You can adjust the copy density to make
copies darker or lighter.
a
Press
b
Load your document.
c
Enter the number of copies you want.
d
Press a or b to choose Density.
Press OK.
e
Press d or c to make a lighter or darker
copy.
Press OK.
f
If you do not want to change additional
settings, press Mono Start or
Colour Start.
Setting your changes as a
7
new default
You can save the settings for the copy
options you use most often by setting them as
default, such as Quality,
Enlarge/Reduce, Density and
Page Layout. These settings will remain
until you change them again.
a
Press
b
Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
c
After changing the last setting, press
a or b to choose Set New Default.
Press OK.
d
Press 1 to choose Yes.
e
Press Stop/Exit.
(COPY).
(COPY).
7
7