Brother PJ662 PocketJet 6 Print Engine with Bluetooth Hızlı Kurulum Kılavuzu - Sayfa 3
Yazılım Brother PJ662 PocketJet 6 Print Engine with Bluetooth için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Brother PJ662 PocketJet 6 Print Engine with Bluetooth 7 sayfaları. P-touch editor software
Ayrıca Brother PJ662 PocketJet 6 Print Engine with Bluetooth için: Kullanıcı Kılavuzu (14 sayfalar), Kullanıcı Kılavuzu (26 sayfalar)
Sayfayı Yazdır
Installing the
Rechargeable Ni-MH
Battery
a
Open the battery cover by pressing the
cover latch.
1 Battery cover
2 Cover latch
b
Swing the cover open and remove it.
c
Gently insert the battery connector into
the terminal on the inside of the battery
compartment.
3
4
3 Terminal
4 Battery connector
d
Grasp the battery removal ribbon, which
is attached to the inside of the battery
compartment. Make sure that enough
ribbon is exposed after the rechargeable
Ni-MH battery installed so that you can
pull the ribbon to remove the battery.
2
1
2
e
While holding onto the ribbon, tilt the
rechargeable Ni-MH battery and insert it
into the battery compartment. After the
rechargeable Ni-MH battery passes the
outer edges of the compartment, press it
securely into position.
Note
• Make sure that the side of the
rechargeable Ni-MH battery marked
"Ni-MH" faces away from the battery
compartment, otherwise the battery cover
will not close properly.
• The rechargeable Ni-MH battery contains
a heat sensor that stops the flow of
electricity if the battery overheats.
f
Attach the battery cover to the end of the
battery compartment opposite the
AC/DC connector. Close and latch the
cover. If necessary, gently push the
cover latch towards the AC/DC
connector until it latches.
Note
• Be careful that you do not pinch the
battery connector cord.
• The voltage supplied by the rechargeable
Ni-MH battery fluctuates. The printing
speed may also fluctuate depending on
the voltage.