Fujitsu F2MC-16L Series Kullanım Kılavuzu - Sayfa 21
Anakart Fujitsu F2MC-16L Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Fujitsu F2MC-16L Series 26 sayfaları.
Ayrıca Fujitsu F2MC-16L Series için: Uygulama Notu (23 sayfalar)
Sayfayı Yazdır
4. USER I/F SPECIFICATIONS
Table 10 and Table 11 summarize the correspondence between pin numbers of probe connector A/
B and the evaluation MCU.
The evaluation MCU signal names in the tables are temporary names. Note that the actual signal
names vary depending on the model. Evaluation MCU signal names can be determined from evalu-
ation MCU pin numbers. For details, contact the sales or support representative.
Descriptions of evaluation MCU signal names and relevant precautions are given below:
Notes:
• To control the evaluation MCU, additional circuits are added to the pins whose evaluation MCU signal names are
underlined. Therefore, its electrical characteristics differ from those of an actual MCU. See the following sections
for details on an additional circuit for each signal:
• On the emulator, UV
are used only for detecting voltage, no circuits consume a large amount of power.
• Use of the flat cable (standard) supplied with the emulator unit is recommended in order to prevent noise problems.
Probe connector B1/B2 and the flat cable connector have the following part numbers:
• Regarding mounting of probe connector B1/B2 on the user system, note the layout of pin numbers of probe con-
nector B1/B2 on the user system. Figure 16 shows the correspondence between probe connector B1/B2 pin numbers
on the adapter board and those on the user system when a flat cable is used.
• PIDA: Probe connection detection signal of probe connector A. This signal is connected to
GND on the probe cable. When connecting a flat cable to probe connector B, leave
this pin open (NC) on the user system.
• PIDB: Probe connection detection signal of probe connector B. When connecting a flat ca-
ble, connect this pin on the user system to GND.
• UV
1: Main power supply of the evaluation MCU
CC
• UV
2: Secondary power supply of the evaluation MCU. This power supply is connected to
CC
V
2 (Pin 22) of the evaluation MCU.
CC
• GND: Ground of the evaluation MCU
• X0/X1
• PA1/PA2 (X0A/X1A)
• P70 (C-pin)
• P00 to P07/P10 to P17
1 and UV
2 are mainly used as evaluation MCU power supplies. On other devices, they
CC
CC
• Probe connector B1/B2: 8930E-100-178MS-F (KEL company product)
• Flat cable connector : 8925E-100-179-F (KEL company product)
: "■ Clock supply"
: "■ Clock supply"
: "■ Setting of the C-pin"
: "■ Setting of the user data bus"
17