Fujitsu F2MC-8FX Series Kurulum Kılavuzu - Sayfa 8

Anakart Fujitsu F2MC-8FX Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Fujitsu F2MC-8FX Series 30 sayfaları. 8-bit microcontroller
Ayrıca Fujitsu F2MC-8FX Series için: Kullanım Kılavuzu (20 sayfalar), Uygulama Notu (12 sayfalar), Uygulama Notu (23 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (19 sayfalar), Uygulama Notu (20 sayfalar), Uygulama Notu (21 sayfalar), Kullanım Kılavuzu (21 sayfalar), Kurulum Kılavuzu (23 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Kurulum Kılavuzu (17 sayfalar)

4.1 Configuration of Each Product

This section describes how to configure the MCU Board and the Evaluation Board.

■ Configuring MCU Board

Set the following switches on the MCU Board, referring to "Figure 1 MCU Board Configuration".

(3)

PRODUCT SELECT

(5)

(1) LVD2 detection voltage selection jumper plug

Set the value to "LVD0".

(2) Voltage selector switch

Set the value to "3V".

(3) Product selector switch

Rotate the center tab to position the pointer for the corresponding number:

For 100-pin package, set the value to "0".

For 80-pin package, set the value to "1".

For 64-pin package, set the value to "2".

For 48-pin package, set the value to "3".

For none of the above, check on the settings in the MCU Board manual.

(4) LVD selector switch

Set the value to "OFF".

(5) Miscellaneous switches

Set "CLK" to "OFF" if you use subclock, or "ON" if you don't.

Set the other switches to "OFF" (to the side of numeral letters).

(6) Clock input selector switch

Set all to "OFF" (to the side of numeral letters)".

(7) Subclock selector jumper plug

Set all the values to the side of "B-C".

(2)

GNDVCC

1 2 3 4

BGM

ADAPTER

(7)

Figure 1 MCU board configuration

(1)

(4)

(6)