Fujitsu MB91460 SERIES Kullanıcı Kılavuzu - Sayfa 29
Anakart Fujitsu MB91460 SERIES için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fujitsu MB91460 SERIES 45 sayfaları. 32-bit microcontroller
Ayrıca Fujitsu MB91460 SERIES için: Başlarken (41 sayfalar), Uygulama Notu (23 sayfalar), Uygulama Notu (26 sayfalar), Uygulama Notu (29 sayfalar), Uygulama Notu (29 sayfalar)
Sayfayı Yazdır
4 Connectors
4.1 Power connector (X6)
The following figure shows the power connection jack X6. This connector is used to connect
an external unregulated DC power supply voltage (9V-12V DC) to the evaluation board.
Connector X6:
The switching mode voltage regulators allow a wide input range. This might be of interest
when using Vin to power the LIN bus Vs line.
4.2 Edge connector (J1, J2, J3, J4)
All pins (except oscillator Pins) of the microcontroller are directly connected to J1 – J4 as
follows:
Connector
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
© Fujitsu Microelectronics Europe GmbH
SK-91467R-176PMC User Guide
Chapter 4 Connectors
Shield is connected to positive voltage supply
+
Center is connected to ground (GND)
Figure 4-1: Power Connector
MCU Pins
J1
1 – 44
J2
45 – 88
J3
89 – 132
J4
133 – 176
- 29 -
FMEMCU-UG-910053-16