Fujitsu QFP-100P Kullanım Kılavuzu - Sayfa 10

Anakart Fujitsu QFP-100P için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Fujitsu QFP-100P 16 sayfaları. F2mc-8fx family 0.65 mm pitch header board

Sayfayı Yazdır

6. Mounting Mass Production MCUs

■ Mounting

To mount a mass production MCU on the user system, use the supplied HQPACK (IC socket cover)

(See Figure 6) .

1. To mount a mass production MCU on the user system, match the index mark (▲) on the NQ-

2. Confirm that the mass production MCU is correctly mounted on the NQPACK. Next, match the

3. Insert each screw for securing HQPACK in each of four drilled holes on the HQPACK, and then

■ Disconnection

To remove the HQPACK, remove all of the four screws and pull out the HQPACK vertically from

the NQPACK. When you take out the mass production MCU, the mass production MCU is handled

by using a vacum pick-up tool. Do not attempt to remove the mass production MCU forcibly, for

example, using a screwdriver as doing so can bend the pins of the mass production MCU or break

the NQPACK.

PACK mounted on the user system with the index mark (●) on the mass production MCU.

index mark of HQPACK with the index mark of NQPACK and insert it (angle cut linearly at one

place only) .

The pin of HQPACK is thin and easy to bend. Insert NQPACK after confirm that the pin of HQ-

PACK is not bent.

tighten the screws diagonally.

To tighten the screws, use the special screwdriver supplied with the NQPACK to finally tighten

the four screws in sequence. Tightening the screws too tight might result in a defective contact.

User system

Figure 6 Mounting a mass production MCU

Screws for securing HQPACK

HQPACK

Mass production MCU

NQPACK