Fujitsu SK-91465X-100PMC Kullanıcı Kılavuzu - Sayfa 27
Anakart Fujitsu SK-91465X-100PMC için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fujitsu SK-91465X-100PMC 40 sayfaları.
Sayfayı Yazdır
SK-91465X-100PMC User Guide
Chapter 5 Connectors
5 Connectors
5.1 Power Connector (X13)
The following figure shows the power connection jack of the starter kit. This connector is
used to connect an external unregulated DC power supply voltage (12V DC max. 2600mA).
Shield is connected to positive voltage supply (+)
Centre is connected to ground (GND)
Figure 5-1: Power Connector
5.2 Edge connector (X4, X5)
All pins (except oscillator Pins) of the microcontroller are directly connected to X4 and X5 as
follows:
Connector
MCU Pins
X4 (1 – 50)
1 – 50
X25 (51 – 100)
51 – 100
Table 5-1: MCU Pin Connectors
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
© Fujitsu Microelectronics Europe GmbH
- 27 -
UG-910056-11