Fujitsu SK-96380-120PMT Kullanıcı Kılavuzu - Sayfa 36

Anakart Fujitsu SK-96380-120PMT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fujitsu SK-96380-120PMT 42 sayfaları. Mb96300 series

6) After that, switch S1 to On, On, Off, X, and reset the microcontroller.

The software now automatically writes a flash loader to the microcontroller ("Download"),

does a blank check and erases the Flash memory if necessary. After that the user

application is programmed to the embedded Flash memory ("Program & Verify").

If the programming sequence has ended successfully, you will receive the output "It all

ended normally completely".

7.2 Synchronous Mode

In order to program the Flash-ROM synchronously special third-party soft- and hardware has

to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.

A dedicated Flash programming socket (X4) is provided on the evaluation-board for direct

connection to this programmer.

X4: Flash programming socket

FMEMCU-UG-960001-15

SK-96380-120PMT User Guide

Chapter 7 Programming the internal Flash memory

Figure 7-1: Settings for Automatic Mode

Figure 7-2: Flash Programming Socket

- 36 -

n/c 1

2 n/c

MD0 3

4 MD2

RST 5

6 SIN2

SOT2 7

8 SCK2

VCC 9

10 GND