Indesit 47857 Hizmet Bilgileri - Sayfa 5
Yıkayıcı Indesit 47857 için çevrimiçi göz atın veya pdf Hizmet Bilgileri indirin. Indesit 47857 23 sayfaları.
Sayfayı Yazdır
INSTALLATION
Unpacking
1. Unpack the washing machine.
2. Check whether the washing machine has
been damaged during transport. If this is the
case, do not install it and contact your
retailer.
3. Remove the three protective screws and
the rubber washer with the respective
spacer, situated on the rear of the appliance
(see figure below).
4. Seal the gaps using the plastic plugs
provided.
5. Keep all the parts as they will be required
again if the washing machine needs to be
moved to another location.
Customer/Installer may remove the
WRONG bolt as both are close together
and not shown in the diagram in the user
instruction book.
The incorrect bolt is indicated below.
This bolt secures the plate in place.
Incorrect Bolt
Levelling
1. Install the washing machine on a flat sturdy
floor, without resting it up against walls,
cabinets etc.
2. If the floor is not
perfectly level,
compensate for any
unevenness by
tightening or
loosening the
adjustable front feet
(see figure); the
angle of inclination, measured according to
the worktop, must not
exceed 2°.
Levelling your appliance correctly will
provide it with stability and avoid any
vibrations, noise and shifting during
operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to
allow enough room for ventilation beneath
the machine.
Water Connections
1. Insert the seal A into the
end of the inlet hose and
screw the latter onto a
cold water tap with a 3/4"
BSP threaded
connection. See figure.
Before making the
connection, allow the
water to run freely until it
is perfectly clear.
2. Connect the
other end of the
water inlet hose
washing
machine,
screwing it into
appliance's cold
water inlet
situated on the
top right hand
side on the rear of the appliance..
3. Make sure there are no kinks or bends in
the hose.
! The water pressure at the tap must be
within the values indicated in the
Specifications page.
5
A