Indesit XWA 81283 Kullanım Kılavuzu - Sayfa 3

Yıkayıcı Indesit XWA 81283 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Indesit XWA 81283 11 sayfaları.

Sayfayı Yazdır

Connecting the drain hose

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose

and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electri-

city socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the maxi-

mum power load of the appliance as indicated

in the Technical data table (see opposite);

• the power supply voltage falls within the va-

lues indicated in the Technical data table (see

opposite);

• the socket is compatible with the plug of the

washing machine. If this is not the case, repla-

ce the socket or the plug.

! The washing machine must not be installed

outdoors, even in covered areas. It is extreme-

ly dangerous to leave the appliance exposed

to rain, storms and other weather conditions.

! Once the machine has been installed, the

electricity socket should be easily accessible.

! Avoid using any extension cord or multiple

socket outlet.

! CAUTION: if this appliance is supplied from a

cord extension set or electrical portable outlet

device, the cord extension set or electrical porta-

ble outlet device must be positioned so that it is

not subject to splashing or ingress of moisture.

Connect the drain

hose, without bending

it, to a drain duct or

a wall drain situated

between 65 and 100

cm from the floor;

alternatively, placed

it over the edge of a

basin, sink or tub, fa-

stening the duct sup-

plied to the tap (see

figure). The free end

of the hose should

not be underwater.

! The cable should not be bent or compressed.

! The cable should be replaced only by autho-

rised technicians.

! If the supply cord is damaged, it must be

replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid

a hazard.

Warning! The company shall not be held

responsible in the event that these regulations

are not respected.

The first wash cycle

Once the appliance has been installed, and

before you use it for the first time, run a wash

cycle with detergent and no laundry, using the

programme "Auto Clean" (see "Cleaning the

washing machine").

Technical data

Model

XWA 81283

width 59.5 cm

height 85 cm

Dimensions

depth 60.5 cm

Capacity

from 1 to 8 kg

please refer to the technical

Electrical

data plate fixed to the ma-

connections

chine

maximum pressure

1 MPa (10 bar)

Water

minimum pressure

connections

0.05 MPa (0.5 bar)

drum capacity 62 litres

Spin speed

up to 1200 rotations per minute

Energy ra-

ted

program 8 (Cotton 60°);

programmes

temperature 60°C; 1200

according to

rpm, using a load of 8 kg.

AS/NZS

2040.2

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electroma-

gnetic Compatibility)

- 2006/95/EC (Low Voltage)

- 2012/19/EU

AUS