Indesit BAA 35 P Kullanım Talimatları Kılavuzu - Sayfa 12
Buzdolabı Indesit BAA 35 P için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit BAA 35 P 16 sayfaları. Refrigerator/freezer combination
+ buzzer
+ buzzer
• The plug has not been inserted into the electrical socket, or not far enough
to make contact, or there is no power in the house.
• The appliance comes with a motor protection control ( see Start-up and use ).
• Pull out and reverse the plug before putting it back in the socket.
The refrigerator door has remained open for more than two minutes (the
buzzer will stop sounding when you shut the door) or the correct switching-
off procedure was not followed ( see Maintenance ).
The temperature in the freezer is too high. Check the quality of the food
products and dispose if necessary.
The temperature in the freezer has reached a dangerous level. The food
must be disposed immediately.
b/c)
In the first case the freezer will maintain a temperature of about 0°C so that
the food does not re-freeze. In the second case, however, the temperature
will remain at approximately -18°C.
To turn off the acoustic signal open and close the refrigerator door. To
restore normal operation bring the FREEZER OPERATION knob setting to
(off) and turn the appliance on again.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The OPERATION knobs are not on the correct setting ( see Description ).
• The refrigerator or the freezer have been over-filled.
• The REFRIGERATOR OPERATION knob is not on the correct setting ( see
Description ).
• The food is in contact with the back inside wall of the refrigerator.
• The SUPER FREEZE button has been pressed (rapid freezing): the yellow
SUPER FREEZE light is on or flashing ( see Description ).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
• The thickness of the frost exceeds 2-3 mm ( see Maintenance ).
• The refrigerator door is open.
• The Aircooler system is only activated automatically when it becomes
necessary to restore perfect operational conditions inside the refrigerator
compartment.
• The appliance has not been installed on a level surface ( see Installation ) .
• The appliance has been installed between cabinets that vibrate and make
noise.
• The internal refrigerant makes a slight noise even when the compressor is
off. This is not a defect, it is normal.
• The water discharge hole is blocked ( see Maintenance ).