Indesit IDL 60 Kurulum ve Kullanım Kılavuzu - Sayfa 6
Bulaşık Makinesi Indesit IDL 60 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Indesit IDL 60 17 sayfaları. Dishwasher
Ayrıca Indesit IDL 60 için: Kurulum ve Kullanım Kılavuzu (44 sayfalar)
Sayfayı Yazdır
- 1. Safety Is a Good Habit to Get into
- 2. Close-Up View (Control Panel)
- 3. Close-Up View (Interior)
- 4. Detergent and Rinse Aid
- 5. Loading the Dishwasher
- 6. Turning on the Appliance
- 7. Wash Cycle Table
- 8. Energy Saving Tips
- 9. How to Keep Your Dishwasher in Shape
- 10. Cleaning and Special Maintenance
- 11. Troubleshooting
- 12. Installation
Detergent and Rinse Aid ....
Detergent
Detergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the
start of each wash cycle following the instructions provided
in the "Wash Cycle Table." The detergent dispenser is
located on the inside panel of the door.
Loading the detergent
To open lid "A", press button "B". The cleaning detergent
should be introduced into the two containers "C"and
"D" up to the rim.
After pouring in the detergent, replace the lid, pressing
down until it clicks.
Dishwasher detergent in tablets is now available on the
market, in which case you should place one tablet into
container "D" and replace the lid.
B
D
Notice: To facilitate closing the cover, remove any
excess detergent on the edges of the dispenser.
Warning
Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.
If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent
the formation of white streaks on your dishes or on the interior of the appliance.
Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.
If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.
In any case, please read the manufacturer's instructions on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain
number of cycles.
GB
C
A
Rinse Aid
This product makes dishes sparkle more as it improves their
drying. The rinse aid container is situated on the inside of
the door: It should be filled up when the low rinse aid
indicator light "F" flashes.
Loading the Rinse Aid
To open the dispenser, turn the "C" cap in the anti-clockwise
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the "F" dose adjustor, located beneath
the "C" cap, with a screwdriver. There are 6 different
settings; the normal dosage setting is 4.
Important:
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs,
the dosage adjustor should be turned to a higher setting. If
the dishes have white streaks, turn the dosage adjustor to
a lower setting.
4
F
C