Indesit 7OIF 896K GP.A RU Kullanım Talimatları Kılavuzu - Sayfa 3
Fırın Indesit 7OIF 896K GP.A RU için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit 7OIF 896K GP.A RU 24 sayfaları.
Electrical connection
! ! ! ! ! Ovens equipped with a three-pole power supply
cable are designed to operate with alternating
current at the voltage and frequency indicated on
the data plate located on the appliance ( see below ).
Fitting the power supply cable
code: Blue (N), Brown (L) and Yellow-Green (
Connecting the electricity supply cable to the
mains
Install a standardised plug corresponding to the
load indicated on the data plate ( see table ).
The appliance must be directly connected to the
mains using an omnipolar switch with a minimum
contact opening of 3 mm installed between the
appliance and the mains. The switch must be
suitable for the charge indicated and must comply
with current electrical regulations (the earthing wire
must not be interrupted by the switch). The supply
cable must be positioned so that it does not come
into contact with temperatures higher than 50°C at
any point.
! ! ! ! ! The installer must ensure that the correct electrical
connection has been made and that it is fully
compliant with safety regulations.
Before connecting the appliance to the power
supply, make sure that:
• The appliance is earthed and the plug is compliant
with the law.
1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
( see diagram ).
2. Loosen the cable
clamp screw and
remove it, using a
screwdriver as a lever
( see figure ).
3. Remove the wire
contact screws L-N-
,
then fasten the wires
under the screw heads,
observing the colour
).
• The socket can withstand the maximum power of
the appliance, which is indicated on the data
plate ( see below ).
• The voltage is in the range between the values
indicated on the data plate ( see below ).
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.
! ! ! ! ! Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
! ! ! ! ! The cable must not be bent or compressed.
! ! ! ! ! The cable must be checked regularly and replaced
by authorised technicians only ( see Assistance ).
! ! ! ! ! The manufacturer declines any liability should
The manufacturer declines any liability should
The manufacturer declines any liability should
The manufacturer declines any liability should
The manufacturer declines any liability should
these safety measures not be observed.
these safety measures not be observed.
these safety measures not be observed.
these safety measures not be observed.
these safety measures not be observed.
TABLE OF CHARACTERISTICS
width 43.5 cm
Dimensions
height 32 cm
depth 40 cm
Volume
56 l
voltage: 220 - 240 V~ 50 Hz
Electrical
maximum power absorbed 2800
connections
W (see data plate)
Directive 2002/40/EC on the label
of electric ovens.
Standard EN 50304
Energy consumption for Natural
convection – heating mode:
ENERGY LABEL
Traditional mode
Declared energy consumption for
Forced convection Class – heating
mode:
Gratin.
This appliance conforms to the
following European Economic
Community directives:
2006/95/EEC dated 12.12.06 (Low
Voltage) and subsequent
amendments – 2004/108/EEC
dated 15/12/04 (Electromagnetic
Compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent
amendments. - 2002/96/EEC and
subsequent amendments.
1275/2008 stand-by/off mode.
GB
3