Indesit BIMS 53 K.A B IX GB S Kullanım Talimatları Kılavuzu - Sayfa 11
Fırın Indesit BIMS 53 K.A B IX GB S için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit BIMS 53 K.A B IX GB S 16 sayfaları.
Ayrıca Indesit BIMS 53 K.A B IX GB S için: Kullanım Talimatları Kılavuzu (16 sayfalar)
Sayfayı Yazdır
Maintenance and care
Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
• The stainless-steel or enamel-coated external
parts as well as the rubber seals may be cleaned
using a sponge that has been soaked in lukewarm
water and neutral soap. If these stains are difficult
to remove, use only specialised products. After
cleaning, rinse and dry thoroughly. Do not use
abrasive powders or corrosive substances.
• Ideally, the inside of the oven should be cleaned
after each use, when it is still lukewarm. Use hot
water and detergent, rinse and dry with a soft cloth.
Do not use abrasive products.
• All accessories can be washed like everyday
crockery, and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack.
clean more thoroughly, you can remove the oven door.
1. Open the oven door fully (see diagram)
2. Lift up and turn the small levers located on the two
hinges (see diagram)
3. Grip the door on the two external sides and close
it approximately half way. Then pull the door towards
you lifting it out of its seat (see
diagram).
To replace the door, reverse
this sequence.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Inspecting the seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre (see Assistance). We
recommend not using the oven until the seals have
been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar
one: Wattage 25 W, cap E 14.
3. Replace the glass cover (see diagram).
! Do not use the oven lamp as/for ambient lighting
To
GB
11