Indesit FGIM K IX Kullanım Talimatları Kılavuzu - Sayfa 16

Fırın Indesit FGIM K IX için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit FGIM K IX 48 sayfaları.

Sayfayı Yazdır

! Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only ( see Assistance ).

! The manufacturer declines any liability should these

safety measures not be observed.

Gas connection

The appliance should be connected to the main gas

supply or to a gas cylinder in compliance with

current National regulations. Before carrying out the

connection, make sure the cooker is compatible with

the gas supply you wish to use. If this is not the

case, follow the instructions indicated in the

paragraph "Adapting to different types of gas."

When using liquid gas from a cylinder, install a

pressure regulator that complies with current

National regulations.

! Check that the pressure of the gas supply is

consistent with the values indicated in Table 1

("Burner and nozzle specifications") since this will

ensure the safe operation and longevity of your

appliance while maintaining efficient energy

consumption.

! Should you need to install a gas hob on top of a

built-in gas oven, it is strictly forbidden to connect

the two or to use a single cut-off tap. The two

appliances should be connected separately, and

each one should have its own stop tap in order to

make them completely independent from one

another ( see figures ).

Connection with a rigid pipe (copper or steel)

! Connection to the gas system must be carried out

in such a way as not to place any strain of any kind

on the appliance.

There is an adjustable L-shaped pipe fitting on the

appliance supply ramp and this is fitted with a seal in

order to prevent leaks. The seal must always be

replaced after rotating the pipe fitting (the seal is

provided with the appliance). The gas supply pipe

fitting is a threaded 1/2 gas cylindrical male

attachment.

Connecting a flexible jointless stainless steel

pipe to a threaded attachment

The gas supply pipe fitting is a threaded 1/2 gas

cylindrical male attachment.

These pipes must be installed so that they are never

longer than 2000 mm when fully extended. Once

connection has been carried out, make sure that the

flexible metal pipe does not touch any moving parts

and is not compressed.

! Only use pipes and seals that comply with current

National regulations.

Checking the tightness of the connection

! When installation has been completed, check the

pipe fittings for leaks using a soapy solution. Never

use a flame.

Adapting to different types of gas

In order to adapt the oven to a type of gas other

than the type for which it was manufactured

(indicated on the label), follow these simple steps:

• Replacing the oven burner nozzle

1. Open the oven door fully.

2. Slide out the bottom of the

oven.

3. Unscrew the burner

fastening screws.

4. Remove screw "V V V V V " and

then the oven burner.

5. Unscrew the oven burner

nozzle using the special

socket spanner for the

nozzles, or better still a 7 mm

socket spanner, and replace it

with a nozzle suited to the

new type of gas (see Table 1) .

6. Replace all the parts, following the steps

described above in the reverse order.

! Take particular care when handling the spark

plug wires and the thermocouple pipes.