Indesit K3M5 S. A/U Kullanım Talimatları Kılavuzu - Sayfa 7

Fırın Indesit K3M5 S. A/U için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit K3M5 S. A/U 29 sayfaları. Cooker and oven

Sayfayı Yazdır

Start-up and use

Using the hob

Lighting the burners

For each BURNER knob there is a full ring showing

the strength of the flame for the relevant burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired

level by turning the BURNER knob in an

anticlockwise direction. This may be the minimum

setting C, the maximum setting E or any position in

between the two.

If the appliance is fitted with

an electronic lighting

device* ( C ), press the

BURNER knob and turn it in

an anticlockwise direction,

towards the minimum flame

setting, until the burner is lit.

The burner may be

extinguished when the knob is released. If this

occurs, repeat the operation, holding the knob down

for a longer period of time.

f the appliance is equipped with a flame failure

safety device (X), press and hold the BURNER knob

for approximately 3-7 seconds to keep the flame

alight and to activate the device.

! If the flame is accidentally extinguished, switch off

the burner and wait for at least 1 minute before

attempting to relight it.

To switch the burner off, turn the knob until it

reaches the stop position •.

Electric hotplates

The corresponding knob may be turned clockwise or

anti-clockwise and set to any of the six different

positions:

Settin g N orm al o r Fast P late

O ff

Low

2 - 5

M edium

H igh

When the selector knob is in any position other than

the off position, the 'on' light is illuminated.

Only available in certain models.

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas

consumed, it is recommended that only pans that

have a lid and a flat base are used. They should

also be suited to the size of the burner:

Burner

ø Cookware diameter (cm)

Fast (R)

Semi Fast (S)

Auxiliary (A)

To identify the type of burner, please refer to the

diagrams contained in the "Burner and nozzle

specifications".

Using the oven

! The first time you use your appliance, heat the

empty oven with its door closed at its maximum

temperature for at least half an hour. Ensure that the

room is well ventilated before switching the oven off

and opening the oven door. The appliance may emit

a slightly unpleasant odour caused by protective

substances used during the manufacturing process

burning away.

! Before operating the product, remove all plastic

film from the sides of the appliance.

! Never put objects directly on the bottom of the

oven; this will avoid the enamel coating being

damaged.

! Should the appliance be equipped with an

electronic programmer*, to use the electric oven, just

press buttons

and

symbol will appear on the display) before

selecting the desired cooking function.

1. Select the desired cooking mode by turning the

SELECTOR knob.

2. Select the recommended temperature for the

cooking mode or the desired temperature by turning

the THERMOSTAT knob.

A list detailing cooking modes and suggested

cooking temperatures can be found in the relevant

table ( see Oven cooking advice table ).

During cooking it is always possible to:

• Change the cooking mode by turning the

SELECTOR knob.

• Change the temperature by turning the

THERMOSTAT knob.

24 - 26

16 - 20

10 - 14

at the same time (the