Indesit SX 896L PX Kullanım Talimatları Kılavuzu - Sayfa 12

Fırın Indesit SX 896L PX için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit SX 896L PX 20 sayfaları. Oven

Sayfayı Yazdır

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

• Slight differences in colour on the front of the oven

are due to the different materials used, i.e. glass,

plastic or metal.

• Any shady areas resembling grooves on the oven

door glass are caused by reflections from the

oven light.

• The enamel is branded at very high temperatures.

This process may cause colour variations. This is

normal and will not affect appliance operation in

any way. The thin edges of the sheet metal

cannot be entirely enamelled and may therefore

appear to be unfinished. This will not affect the

rust protection.

• The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding

racks - can be washed like everyday crockery,

and are even dishwasher safe.

• We recommend that detergents are not sprayed

directly onto the control panel, but that a sponge

is used instead.

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

! The door of LED INSIDE models cannot be

removed.

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

For more thorough cleaning purposes, the oven door

may be removed:

1. Open the oven door fully ( see diagram ).

2. Use a screwdriver to lift up and turn the small

levers F F F F F located on the two hinges ( see diagram ).

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

3. Grip the door on the two

outer sides and close it

approximately half way. Pull

the door towards you, lifting it

out of its slot ( see diagram ).

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If

the seals are damaged, please contact your nearest

Service Centre ( see Assistance ). We recommend

that the oven is not used until the seals have been

replaced.

Replacing the light bulb

Lamp Holder

compartment

Lamp

Glass cover

wattage 25 W, cap G 9.

3. Replace the glass cover ( see diagram ).

! Do not touch the light bulb directly with your

hands.

Sliding rack kit assembly

To replace the

oven light bulb:

1. Remove the

glass cover of the

lamp-holder.

2. Remove the

light bulb and

replace it with a

similar one:

halogen lamp

voltage 230 V,

To assemble the

sliding racks:

1. Remove the two

frames, lifting them

away from the spacers

A ( see figure ).