Indesit K3G11/AUS Kullanım Talimatları Kılavuzu - Sayfa 14
Ocaklar Indesit K3G11/AUS için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit K3G11/AUS 16 sayfaları. Indesit cookers operating instructions
Sayfayı Yazdır
Care and maintenance
Switching The Appliance Off
AUS
Disconnect your appliance from the electricity supply
before carrying out any work on it.
DO NOT TOUCH HOT SURFACES. ALLOW
COOKTOP AND ALL OVEN SURFACES TO COOL
COMPLETELY BEFORE CLEANING.
Cleaning The Appliance
! Do not use abrasive or corrosive detergents such as
stain removers, anti-rust products, powder detergents or
sponges with abrasive surfaces: these may scratch the
surface beyond repair.
! Never use steam cleaners or pressure cleaners on the
appliance.
• It is usually sufficient simply to wash the hob using a
damp sponge and dry it with absorbent kitchen roll.
• The stainless steel or enamel-coated external parts and
the rubber seals may be cleaned using a sponge that
has been soaked in lukewarm water and neutral soap.
Use specialised products for the removal of stubborn
stains. After cleaning, rinse well and dry thoroughly. Do
not use abrasive powders or corrosive substances.
• The hob grids, burner caps, flame spreader rings and
burners may be removed to make cleaning easier;
wash them in hot water and non-abrasive detergent,
making sure all burnt-on residue is removed before
drying them thoroughly.
• For hobs with electronic ignition, the terminal part of the
electronic lighting devices should be cleaned
frequently and the gas outlet holes should be checked
for blockages.
• The inside of the oven should ideally be cleaned after
each use, while it is still lukewarm. Use hot water and
detergent, then rinse well and dry with a soft cloth. Do
not use abrasive products.
•
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth.
• Do not use harsh abrasive cleaners or materials,
or metal scrapers to clean the oven door glass
since these can scratch the surface, which may
result in shattering of the glass.
14
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
• Stainless steel can be marked by hard water that has
been left on the surface for a long time, or by
aggressive detergents containing phosphorus. After
cleaning, rinse well and dry thoroughly. Any remaining
drops of water should also be dried.
Inspecting The Oven Seals
Check the door seals around the oven regularly. If the
seals are damaged, please contact your nearest
Authorised After-sales Service Centre. We recommend
that the oven is not used until the seals have been
replaced.
Gas Tap Maintenance
Over time, the taps may become jammed or difficult to
turn. If this occurs, the tap must be replaced.
!This procedure must be performed by a qualified
technician authorised by the manufacturer.
Replacing The Oven Light Bulb
1. After disconnecting the oven
from the electricity mains, remove
the glass lid covering the lamp
socket ( see figure ).
2. Remove the light bulb and
replace it with a similar one:
voltage 230 V, wattage 25 W, cap
E 14.
3. Replace the lid and reconnect the oven to the electricity
supply.
Cleaning The Cooktop
• Always wipe spills up when they occur. Do not
leave spills to dry onto the surface of the hob.
• It is usually enough to wash the hob with a damp
sponge and dry it with absorbent kitchen roll.
• NOTE: Do not put hot components in cold water.
The sudden temperature shock could cause the
component to crack.
• Do not use abrasive or corrosive detergents such
as stain removers, anti-rust products, powder
detergents or sponges with abrasive surfaces:
these may scratch the surface beyond repair.