Indesit RID60G2 Kullanım Talimatları Kılavuzu - Sayfa 7
Ocaklar Indesit RID60G2 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Indesit RID60G2 24 sayfaları. Free standing gas cooker
Sayfayı Yazdır
Electrical Connection
WARNING -
THIS APPLIANCE MUST BE
EARTHED.
CONNECT TO A 230-240V A.C. SUPPLY ONLY.
Connection to the electricity supply should be made
via a properly earthed, readily accessible wall socket
which is adjacent to but not directly above, and not
more than 1.25m away from the appliance and capable
of electrical isolation.
The mains lead should be routed such that it cannot
touch hot parts of the cooker i.e. the back panel above
a height of 650mm from the floor.
Should this plug not fit the socket outlet in your home it
should be cut off and replaced with a suitable plug as
outlined below.
NOTE: The removed plug cannot be used for any other
appliance and should therefore be properly disposed
of and not left where children might find it and plug
it into a supply socket - with the obvious consequent
danger.
IF THE FITTED PLUG IS REMOVED
The flexible mains lead must be correctly connected
as below to a three pin plug of not less than 13 amp
capacity. If a B.S. 1363 fused plug is used, it must be
fitted with a fuse which is approved to B.S. 1362.
IMPORTANT: The wires in the mains lead fitted to
this appliance are coloured in accordance with the
following code:
GREEN AND YELLOW
- EARTH
BLUE
BROWN
- LIVE
Blue to
Neutral
Cord
Clamp
- NEUTRAL
Green &
Yellow to
Earth
Brown
to Live
13 Amp
Fuse
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol
coloured green or green and yellow.
The wire which is coloured blue must be connected
to the terminal which is marked with the N or coloured
black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
When wiring the plug, ensure that all strands of wire
are securely retained in each terminal. Do not forget to
tighten the mains lead clamp on the plug.
As the appliance must be earthed, do not use 2-pin
sockets outlets, if you are in doubt, consult a
qualified electrician.
Should the mains lead ever require replacement, it
is essential that this operation be carried out by a
qualified electrician and should only be replaced with
a flexible cord of the same size i.e. 1.0mm2 cross
sectional area PVC cable, available from our parts
department (see Back Cover).
IF A MOULDED PLUG IS FITTED
In the event of replacing a fuse in the plug supplied an
ASTA approved fuse to BS1362 must be fitted.
NOTE: The fuse cover must be refitted when changing
the fuse. In the event of losing the fuse cover the plug
must not be used until a replacement fuse cover has
been obtained and fitted. A new fuse cover can be
obtained from your local Electricity Board. The colour
of the correct replacement fuse cover is that of the
coloured marks or inserts in the base of the plug.
Make sure that the cable does not become trapped
when pushing the cooker into position.
WARNING.
WARNING.
If the electric supply fails to this appliance you must
If the electric supply fails to this appliance you must
not use the grill or ovens.
not use the grill or ovens.
GB
or
7