Indesit BI WDIL 75125 UK N Hızlı Kılavuz - Sayfa 2
Yıkayıcı/Kurutucu Indesit BI WDIL 75125 UK N için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. Indesit BI WDIL 75125 UK N 4 sayfaları.
Sayfayı Yazdır
WASH CYCLES
Follow the instructions on the symbols of the garment's wash
care label. The value indicated in the symbol is the maximum
recommended temperature for washing the garment.
Mixed
For washing lightly to normally soiled resilient garments in cotton, linen,
synthetic fibres and mixed fibres.
Cotton
Suitable for washing towels, underwear, table cloths, etc. made of
resistant linen and cotton that are moderately to heavily soiled.
Synthetics
Suitable for washing moderately soiled garments made of synthetic fibres
(e.g. polyester, polyacrylic, viscose, etc.) or mixed synthetic-cotton fibres.
White
For heavily soiled whites and resistant colours.
Colours
A 30°C cycle that helps to preserve colours, suitable for cotton or
synthetic coloured garments. It allows for reducing electricity
consumption for heating the water while guaranteeing good washing
results. Suitable for lightly soiled garments.
Eco 40-60
For washing normally soiled cotton garments declared to be washable at
40 °C or 60 °C, together in the same cycle. This is the standard cotton
programme and the most efficient in terms of water and energy
consumption.
Sport
A cycle designed for washing lightly soiled sports clothing (tracksuits,
shorts, etc.); for best results, we recommend not exceeding the maximum
load indicated in the "Wash Cycle Table". We recommend using liquid
detergent and adding the amount suitable for a half-load.
20 °C
For washing lightly soiled cotton garments, at a temperature of 20 °C.
Anti Odour
use programme for washing garments with bad odours (e.g. smoke,
sweat, fried food). The programme is designed to remove bad odours
while preserving the fabric fibres. Synthetics fabrics or mixed loads should
be washed at 40°, and resistant cotton fabrics at 60°.
Delicates
use programme to wash very delicate garments. It is advisable to turn the
garments inside out before washing them. For best results, use liquid
detergent on delicate garments.
When selecting an exclusively time-based drying function, a drying cycle is
performed at the end of the wash cycle that is particularly delicate, thanks
to light handling and appropriate temperature control of the water jet.
The recommended durations are:
1 kg of synthetic garments --> 150 min
1 kg of synthetic and cotton garments --> 180 min
1 kg of cotton garments --> 180 min
The degree of dryness depends on the load and fabric composition.
Wool - Woolmark Apparel Care - Blue:
The "Wool" wash cycle is approved by the Woolmark
Company for washing wool garments classified as
"hand-washable", provided that the wash complies with
the instructions appearing on the garment's label and
with those provided by the manufacturer of this washer-
dryer (M1126).
Rapid 30'
For washing lightly soiled garments in a short time. Not suitable for wool,
silk and garments to be washed by hand.
Wash&Dry 45 min
select programme for washing and drying lightly soiled garments (Cotton
and Synthetic) in a short time. This cycle may be used to wash and dry a
laundry load of up to 1 kg in just 45 minutes. To achieve optimum results,
use liquid detergent and pre-treat cuffs, collars and stains.
AirFresh
ideal cycle to refresh garments and remove bad odours, in particular
smoke, from cotton and synthetic items in 30' (max 1.5kg) without the
washing phase.
Rinse + Spin
Designed for rinsing and spinning.
Spin + Drain
Designed to spin and drain the water.
Eco cotton
For washing normally soiled cotton garments at 60°C.
WASH CYCLE PHASE INDICATOR LIGHTS
Once the desired wash cycle has been selected and has begun, the
indicator lights switch on one-by-one to indicate which phase of the cycle
is currently in progress.
Wash
Rinse
Spin/Drain
Drying
END End of Wash Cycle
DOOR LOCKED INDICATOR
When lit, the symbol indicates that the door is locked. To prevent any
damage, wait until the symbol turns off before opening the door.
To open the door while a cycle is in progress, press the START/PAUSE
button; if the indicator light is off, the door can be opened.
FIRST-TIME USE
Once the appliance has been installed, and before it is used for the first
time, run a wash cycle with detergent and no laundry, by setting the
"Auto-Clean" cycle.
DAILY USE
Prepare the laundry by following the suggestions appearing under the
"TIPS AND SUGGESTIONS" section.
Rapid programming
- Turn the washer-dryer on by pressing the ON/OFF
indicator lights will light up for a few seconds, then only the lights
corresponding to the settings for the selected wash cycle will remain lit;
the START/PAUSE
indicator light will also flash.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the cycle table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in "DETERGENT DISPENSER DRAWER
section".
- Close the door.
- Press the PUSH & GO button to start the wash cycle.
Traditional programming
- Turn the washer-dryer on by pressing the ON/OFF
indicator lights will light up for a few seconds, then only the lights
corresponding to the settings for the selected wash cycle will remain lit;
the START/PAUSE
indicator light will also flash.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the Wash Cycle Table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments as described in "DETERGENT DISPENSER
DRAWER" section.
- Close the door.
- Set the WASH CYCLE knob to the desired cycle.
- Modify the temperature: pressing the
reducing the temperature down to the cold wash level ( ).
- Select the desired wash cycle.
- Select the desired options.
- Press the START/PAUSE
button to start the wash cycle; the relative
indicator light will light up steady green and the door will lock (
light on).
PAUSING A CYCLE
To pause the wash cycle, press the START/PAUSE
indicator light will flash . If the
opened. To start the wash cycle from the point at which it was
interrupted, press the START/PAUSE
OPENING THE DOOR, IF NECESSARY
Once a cycle starts, the
indicator light turns on to signal that the door
cannot be opened. While a wash cycle is running, the door remains
locked. To open the door while a cycle is under way, for example, to add
or remove garments, press the START/PAUSE
cycle; the indicator light will flash . If the
door may be opened. Press the START/PAUSE
continue the cycle.
CHANGING A RUNNING WASH CYCLE
To change a wash cycle while it is in progress, pause the washer-dryer
using the START/PAUSE
button (the relative indicator light will flash ),
then select the desired cycle and press the START/PAUSE
again.
! To cancel a cycle that has already begun, press and hold the ON/OFF
button.
The cycle will be stopped and the machine will switch off.
END OF THE CYCLE
Once the cycle terminates the END indicator light will light up; when the
indicator light switches off, the door may be opened. Open the door,
unload the laundry and switch off the machine.If you do not press "ON/
OFF"
button, the washer-dryer will switch off automatically after about
a 10 minutes. Close the water tap, open the door and unload the washer-
dryer. Leave the door ajar to allow the drum to dry.
FUNCTIONS
- If the selected option is not compatible with the set wash cycle, the
indicator light will flash and the option will not be activated.
- If the selected option is not compatible with another previously
selected option, the indicator light will flash accompanied by a buzzer,
and only the latter option will be activated; the indicator light
corresponding to the activated option will turn on.
Stain removal
This option allows for selecting the type of dirt so as to optimally adjust the
cycle for removing the stains. The following types of dirt can be selected:
Food: for stains caused by foodstuffs and beverages, for example.
-
Work: for grease and ink stains, for example.
-
Outdoor: for mud and grass stains, for example.
-
! The wash cycle duration varies according to the type of selected dirt.
Slow Spin
By selecting this function, reduces the spin speed.
Extra rinse
By selecting this option, the efficiency of the rinse is increased and
optimal detergent removal is guaranteed. It is particularly useful for
sensitive skin.
Temperature
Each wash cycle has a pre-defined temperature. To modify the
temperature, press the
button.
Drying
Drying may be set as follows:
button. All the
button. All the
button allows for gradually
button again; the
indicator light is not lit, the door may be
button again.
button to pause the
indicator light is not lit, the
button again to
button
indicator