Indesit TI 60 W Kullanım Kılavuzu - Sayfa 4

Hob Indesit TI 60 W için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Indesit TI 60 W 8 sayfaları.
Ayrıca Indesit TI 60 W için: Kullanım Kılavuzu (8 sayfalar)

Sayfayı Yazdır

CARE AND MAINTENANCE

Cleaning the hob

• Before cleaning the cooking hob, disconnect it from mains power

supply and wait until it has cooled down.

• Important: never clean the appliance with steam cleaning equipment.

• Wipe it with a cloth moistened with hot water and soap or diluted liquid

detergent.

• Do not use abrasive or corrosive products, chlorine products or steel wool.

• Do not leave acid or alkaline substances, such as vinegar, salt or lemon

juice, etc., on the cooking hob.

Stainless steel surface

• Clean it with a specific commercial product.

Note: if the cooking hob is used continuously,the high temperatures

may alter the colour of the hotplates.

Cleaning the electric hotplates

The electric hotplates must be cleaned when they are lukewarm. Wipe

them with a cloth moistened with water and salt, and polish with a cloth

moistened with oil.

AFTER-SALES SERVICE

• Before contacting After-sales Service:

1. Re-start the cooking hob, to check whether correct operation has been

restored.

2. If the malfunction persists, call the After-sales Service.

Give the following information:

• type of malfunction;

• model of cooking hob;

• service number (i.e., the number that follows the word SERVICE on the

rating plate under the cooking hob and on the guarantee paper);

• your complete address;

• your telephone number and area code.

INSTALLATION

Technical information for installer

This cooking hob can be embedded in a worktop 20 to 50 mm thick.

If another appliance is not fitted under the cooking hob, insert a separator

panel, at a distance of at least 90 mm from the cooking hob bottom.

• If a vertical piece of furniture is installed, there must be a gap of at

least 100 mm between it and the edge of the cooking hob.

Installation of cooking hob

• Apply the supplied gasket to the cooking hob (unless it has already

been fitted), after having cleaned its surface as shown in the figure.

A - If the worktop is made out of wood, use the springs supplied.

1. Fit the 4 springs

into the relevant seat under the box.

2. Make an opening in the worktop, respecting the dimensions indicated in

the enclosed product description sheet.

3. Install the cooking hob in the worktop.

B- If the worktop is made out of marble or other materials (plastics, ceramics

or stone), the cooking hob must be fixed by means of brackets

from the After-sales Service (code 4819 310 18528).

1. Align the brackets with the bores and fix them with the screws.

2. Make an opening in the worktop, respecting the dimensions indicated in

the product description sheet.

3. Install the cooking hob in the worktop.

• Before installing the cooking hob, remove the plastic film that protects

it, if present. The outer surfaces of the furniture or appliances adjoining

the cooking hob must be heat resistant (heat protection "Y", according to

standards EN 60335-2-6).

• Installation must comply with current local safety regulations.

If any repairs are required, please contact an authorised After-sales Service

as indicated in the warranty. In the unlikely event that an operation or repair

is carried out by an unauthorised technician, always request a certification

of the job carried out and insist on the use of original spare parts. Failure

to comply with these instructions may compromise the safety and

quality of the product.

to be ordered