AEG 1273-4 GS Kullanım Talimatları Kılavuzu - Sayfa 20

Dondurucu AEG 1273-4 GS için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AEG 1273-4 GS 24 sayfaları. Table top freezer

Sayfayı Yazdır

Malfunction

The freezer temperature is

not sufficient, red light

lights up, temperature

alarm signal sounds.

Heavy build up of frost,

possibly also on the door

seal.

Unsual noises.

The compressor does not

start immediately after

changing the temperature

setting.

Important: regularly check on the red temperature pilot light and

thermometer that the storage temperature is being maintained.

Possible Cause

Temperature is not

properly adjusted.

Door was open for an

extended period.

A large quantity of warm

food placed in the appli-

ance within the last 24

hours.

The appliance is near a

heat source.

Door seal is not air tight

(possibly after changing

over the hinges).

Appliance is not level.

The appliance is touching

the wall or other objects.

A components, e.g. a pipe,

on the rear of the

appliance is touching

another part of the appli-

ance or the wall.

This is normal, no error has

occurred.

Remedy

Please look in the "Initial

Start Up" section.

Open the door only as long

as necessary. Press the fast

freeze switch.

Press the fast freeze

switch.

Please look in the

"Installation Location"

section.

Carefully warm the leaking

sections of the door seal

with a hair dryer (not hot-

ter than approx. 50 °C). At

the same time shape the

warmed door seal by hand

such that it sits correctly.

Readjust the feet.

Move the appliance

slightly.

If necessary, carefully bend

the component out of the

way.

The compressor starts after

a period of time.