AEG ABB812E6NC Kullanıcı Kılavuzu - Sayfa 16
Dondurucu AEG ABB812E6NC için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG ABB812E6NC 20 sayfaları.
Sayfayı Yazdır
16
www.aeg.com
Problem
Door does not open easily.
There is too much frost and
ice.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
Possible cause
You attempted to re-open
the door immediately after
closing.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The "Frostmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
Solution
Wait a few seconds between
closing and re-opening of
the door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Attach the melting water out‐
let to the evaporative tray.
Switch off "Frostmatic func‐
tion" manually, or wait until
the function deactivates au‐
tomatically to set the temper‐
ature. Refer to "Frostmatic
function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.