AEG AGB62226NX Kullanıcı Kılavuzu - Sayfa 8

Dondurucu AEG AGB62226NX için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG AGB62226NX 12 sayfaları.

AEG AGB62226NX Kullanıcı Kılavuzu
8
www.aeg.com
5.2 Periodic cleaning
CAUTION!
Do not pull, move or
damage any pipes and/or
cables inside the cabinet.
CAUTION!
Take care of not to damage
the cooling system.
CAUTION!
When moving the cabinet,
lift it by the front edge to
avoid scratching the floor.
The equipment has to be cleaned
regularly:
1. Clean the inside and accessories with
lukewarm water and some neutral
soap.
2. Regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
3. Rinse and dry thoroughly.

6. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
6.1 What to do if...
Problem
The appliance is noisy.
Audible or visual alarm is
on.
The compressor operates
continually.
4. If accessible, clean the condenser
5.3 Defrosting of the freezer
The freezer compartment is frost free.
This means that there is no build up of
frost when it is in operation, neither on
the internal walls, nor on the foods.
5.4 Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Disconnect the appliance from
2. Remove all food.
3. Clean the appliance and all
4. Leave the door/doors open to
Possible cause
The appliance is not sup-
ported properly.
The cabinet has been re-
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
and the compressor at the back of
the appliance with a brush.
This operation will improve the
performance of the appliance and
save electricity consumption.
electricity supply.
accessories.
prevent unpleasant smells.
Solution
Check if the appliance stands
stable.
Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
Refer to "Operation"/"Control
Panel" chapter.
Wait a few hours and then
check the temperature again.