AEG ARCTIS Kullanıcı Kılavuzu - Sayfa 13

Setting „4" means:

lowest, coldest internal temperature

Recommended regulator setting:

„2-3".

1. Plug the mains plug into the mains socket.

2. Turn the temperature regulator (B) in the direction of „O"; a sound is

on only for 2 sec. The compressor starts and then runs automatically.

3 .The red lamp (E) flashed and the sound alarm signal. Reset the sound

alarm signal pushing the switch (D) . The red switch continuosly flas-

hes. Operate the fast-freeze switch (D) once again. The yellow pilot

lamp (C) comes on.

4. Only when the red light (E) has gone out should you reset the fast-fre-

eze switch (D). The yellow light (C) goes out and the audible warning

mode is activated again.

The temperature regulator (B) can be used to set the required storage

temperature, -18°C or colder.

Important! Wait until the freezer compartment has reached a tempe-

rature of –18°C, or the red warning light has gone out, before storing

frozen food.

Important: Regularly check on the red temperature pilot light (E) and

the thermometer that the required storage temperature is being main-

tained.

Switching off the appliance

To switch off the appliance, turn the thermostat control knob to posi-

tion "0" .

If the appliance is not going to be used for an extended period:

1. Remove all deep-frozen packages as well as ice-trays.

2. Switch off the appliance by turning the temperature regulator to posi-

tion "0" .

3. Remove the mains plug or switch off or disconnect from the electricity

supply.

4. Defrost freezer and clean thoroughly (see sections: "Defrosting" and

"Cleaning and Care").

5. Leave the door open to avoid the build up of odours.