AEG ARCTIS 1333-6 i Çalıştırma ve Kurulum Talimatları - Sayfa 14

Dondurucu AEG ARCTIS 1333-6 i için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. AEG ARCTIS 1333-6 i 24 sayfaları. Aeg integrating freezer arctis
Ayrıca AEG ARCTIS 1333-6 i için: Kullanım ve Kurulum Kılavuzu (23 sayfalar), Çalıştırma ve Kurulum Talimatları (24 sayfalar)

Sayfayı Yazdır

Symptom

Appliance does not work.

Appliance cools too much.

The food is too warm.

Heavy build up of frost, pos-

sibly also on the door seal.

The compressor does not

start immediately after chan-

ging the temperature set-

ting.

If, after carrying out the necessary checks there is still a fault with

your appliance please contact your local AEG Service Force Centre.

In guarantee customers should ensure that the suggested

checks have been made as the engineer will make a charge if the

fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee

service calls.

Possible Cause

Appliance is not switched on Switch on the appliance.

Mains plug is not plugged in

or is loose.

Fuse has blown or is defec-

tive.

Socket is defective.

Temperature is set too cold. Turn the temperature control

Temperature is not properly

adjusted.

Door was open for an exten-

ded period.

A large quantity of warm food

was placed in the appliance

within the last 24 hours.

The appliance is near a heat

source.

Door seal is not air tight

(possibly after changing

over the hinges).

This is normal, no error has

occurred.

Remedy

Insert mains plug.

Check fuse, replace if

necessary.

Mains malfunctions are to be

corrected by an electrician.

knob to a warmer setting.

Please look in the "Initial

Start Up" section.

Open the door only as long

as necessary.

Turn the temperature control

knob to a colder setting.

Please look in the "Installa-

tion location" section.

Carefully warm the leaking

sections of the door seal

with a hair dryer (not hotter

than approx. 50 ¡C). At the

same time shape the war-

med door seal by hand until

it sits correctly.

The compressor starts after

a period of time.