AEG ARCTIS G 9 18 50-4 i Çalıştırma ve Kurulum Talimatları - Sayfa 14
Dondurucu AEG ARCTIS G 9 18 50-4 i için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. AEG ARCTIS G 9 18 50-4 i 20 sayfaları. Integrating freezer
Ayrıca AEG ARCTIS G 9 18 50-4 i için: Çalıştırma ve Kurulum Talimatları (21 sayfalar)
Malfunction
The freezer temperature is not
sufficient, red light lights up,
temperature signal sounds
Heavy build up of frost, possi-
bly also on the door seal.
Unusual noises.
The compressor does not start
immediately after changing
the temperature setting.
14
Possible Cause
The appliance is near a heat
source.
Disturbance on the appliance
Door seal is not air tight (pos-
sibly after changing over the
hinges).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Remedy
Please look in the "Installation
location" section.
Switch on the fast freeze
switch, keep the freezer clo-
sed, inform your customer
service
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
The feet are not adjustable.
Move the appliance slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts after a
period of time.