AEG SDS51200S0 Kullanıcı Kılavuzu - Sayfa 29

Dondurucu AEG SDS51200S0 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG SDS51200S0 40 sayfaları.

Sayfayı Yazdır
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
6.1 Replacing the lamp
6.2 Closing the door
Clean the door gaskets.
1.
2.
If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
Possible cause
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
The temperature regula-
tor is not set correctly.
1.
2.
3.
4.
5.
6.
7.
8.
3.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Solution
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Disconnect the mains plug from the
mains socket.
Remove the screw from the lamp
cover.
Remove the lamp cover (refer to the
illustration).
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household appli-
ances. (the maximum power is
shown on the lamp cover).
Install the lamp cover.
Tighten the screw to the lamp cover.
Connect the mains plug to the mains
socket.
Open the door. Make sure that the
lamp comes on.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
29