AEG 6000 Series Kullanıcı Kılavuzu - Sayfa 9

Havalandırma Davlumbazı AEG 6000 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG 6000 Series 24 sayfaları.
Ayrıca AEG 6000 Series için: Kullanıcı Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Kullanıcı Kılavuzu (24 sayfalar)

Sayfayı Yazdır

CAUTION!

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values.

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

3.4 Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in

"Technical Data" chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Attach the label with the new type of

gas supply near the gas supply pipe.

You can find this label in the package

supplied with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure

adjuster on the gas supply pipe.

3.5 Adjustment of minimum

level

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob and the gasket.

WARNING!

Pay attention not to damage

the gasket. Do not use sharp

tool to remove it.

4. With a thin screwdriver, adjust the

bypass screw position (A).

5. If you change:

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn (1/2 of

a turn for Multi Crown burner).

6. Reassemble the gasket and the knob.

ENGLISH