AEG 8160 D Kullanım ve Kurulum Kılavuzu - Sayfa 13

Havalandırma Davlumbazı AEG 8160 D için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. AEG 8160 D 16 sayfaları. Cooker hood
Ayrıca AEG 8160 D için: Çalıştırma ve Kurulum Talimatları (16 sayfalar), Çalıştırma ve Kurulum Talimatları (20 sayfalar), Çalıştırma ve Kurulum Talimatları (18 sayfalar)

Mounting the cooker hood - Fig. 7-8-9

• Position the template on the wall and mark the position, and drill the

holes (2 x Ø 8 mm).

• Mount the two rawl plugs with the hooks (3).

• Hang the hood on the hooks and level it with the adjustment screws

(4).

• Remove the grease filters (5) and mark for the two screws (6).

Remove the hood and drill the holes (2 x Ø 8 mm).

• Insert the rawl plugs (7) and hang the hood on the wall again. Adjust

it horizontally with the screws (8) and secure it with the screws (9).

• Mount the chimney holder (10) with the rawl plugs (12) and the

screws (11).

Warning! Be careful that it is centered over the hood and horizontally

aligned.

Fitting for ducting (S)

Connect a tube between the hood air outlet and the wall or roof exhaust

channel. Fix it with the tube clamps supplied.

Fitting for recirculation (K)

Put the charcoal filter frame in place and fix it with 5 screws. Fig. 7.

Mount the recirculation spigot with the two screws supplied.

Mounting the chimney

• Place the chimney (15) and fix it to the top chimney holder with the

two screws (16) supplied.

• Lower the bottom part of the chimney (17) and fasten it to the top of

the hood with two screws, supplied.

Note that the top part of the chimney can be mounted with the side

grids up or down. For use as a recirculation hood it must be mounted

with the grids upwards. Fig. 8.

Fig. 7

Fig. 8