Kohler 16352 Kurulum Talimatları - Sayfa 3

Sıhhi Tesisat Ürünleri Kohler 16352 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Kohler 16352 4 sayfaları. Showerhead with arm & flange

Sayfayı Yazdır

Install the G1/2" connector(11) to the pipe so it extends 10~18mm

beyond the finished wall. Apply tape or thread sealant to the

connector threads, apply a ring of plumbers putty or sealant around

the flange(12). Slide the flange over the shower arm(13). Install the

shower arm onto the connector(11). Tighten with strap wrench. Push

the flange against the wall. Remove any excess putty.

Flush both water supplies through the shower arm for one minute

before the showerhead is installed. Apply tape or sealant to the

exposed end of the shower arm. Tighten the showerhead(14) with a

strap wrench.

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with

clean soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc.

which could adversely affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler showerheads and fittings.

1069817-2A-A