A-Neuvideo ANI-4K-VW Kullanım Kılavuzu - Sayfa 5

Medya Dönüştürücü A-Neuvideo ANI-4K-VW için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. A-Neuvideo ANI-4K-VW 20 sayfaları. 1x4 hdmi 4k video wall splitter (cascadable)

Sayfayı Yazdır

NEUVIDEO

FRONT PANEL

POWER:

Press the POWER button to power on the unit or set to standby mode. When power is disconnected, press this button again

while connected to the power to reset the system back to default factory settings. When the power is on, press and hold this button for (3)

seconds, the output monitor will show "USB Host Update MCU Firmware Start...", then plug the USB (with the Firmware upgrade bin

file) to upgrade automatically. If monitor shows "Mass Storage Host Upgrade Running", it means that the upgrade is proceeding, after

the upgrade is finished, the unit will reboot.

Note: If monitor did not show "Mass Storage Host Upgrade Running", this means the firmware upgrade was not a success, please

power off the unit and try again.

REAR PANEL

FRONT & REAR PANELS

HDMI IN:

Connects with HDMI source equipment such as a DVD/

Blueray player and/or PC/Laptop devices.

HDMI OUT A~D:

Connects with HDMI TV/displays for output

image display. It is suggested that the connection sequence should

be placed as the diagrams shows for TV wall set up.

SERVICE:

This slot is for firmware update use only. Works with

the power button.

CONTROL:

Connects to an active network for Telnet control.

Controlled with the "ANI-4K-VW" application for multi-device control.

RS-232:

Connects from a PC/Laptop with D-Sub 9pin cables for

RS-232 command control over the device.

Note: RS-232 control system is limited to a single Video Wall unit.

Whereas Telnet can control multi-video Wall units.

DC 12V:

Plug for the 12V DC power supply, which is included in

the package, to the unit, then connect the adaptor to an AC outlet.