A-Neuvideo ANI-HDR-200 Kullanım Kılavuzu - Sayfa 6
Alıcı A-Neuvideo ANI-HDR-200 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. A-Neuvideo ANI-HDR-200 11 sayfaları. Hdmi 18gbps over hdbasettm 2.0 w/ arc transmitter & receiver
Sayfayı Yazdır
A
NEUVIDEO
Transmitter
POWER LED:
System power indicator.
q
ARC LED:
ARC status indicator.
w
ARC BUTTON:
This button will enable or disable the ARC function.
e
• Enable ARC: LED ON
• Disable ARC: LED OFF
• ARC function: If you need to use ARC, your HDTV must support this function, when you open the ARC function, the transmitter
optical out port will output the HDTVs current display content audio signal, otherwise the transmitter optical out port signal will come
from the Receiver's Optical In.
DC 24V:
Connects 24V/1A adaptor to AC wall outlet for power supply.
r
HDBaseT
OUT:
Connects to the HDBaseT
™
t
IR IN:
Connects to a Wideband IR RX cable.
y
IR OUT:
Connects to a Wideband IR TX cable.
u
OPTICAL OUT:
Connects to a speaker with coaxial input for audio signal output from Receiver's Optical In or ARC.
i
HDMI IN:
Connects to the HDMI source device.
o
LAN:
Connects to an active network for LAN sharing for a total transmission rate up to 100Mbps. Or when a compatible LAN equipped
a
Transmitter is connected to an active network, this allows the network access (including internet access if available) to be shared between
the Transmitter and Receiver.
NOTE: Do not connect this RJ-45 port to any of the HDBaseT
RS-232:
Connects to any devices with RS-232 port for RS-232 commands transmission.
s
SERVICE SEL 1/2:
Reserved for firemware update use only.
d
OPERATION CONTROLS & FUNCTIONS
Receiver with a CAT5e/6/7 cable.
™
ports. This may damage this port or the whole device.
™
4