A-Neuvideo ANI-2PIP-LOGO Kullanım Kılavuzu - Sayfa 13
Monitör A-Neuvideo ANI-2PIP-LOGO için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. A-Neuvideo ANI-2PIP-LOGO 20 sayfaları. 2x1 hdmi multiviewer
Ayrıca A-Neuvideo ANI-2PIP-LOGO için: Kullanım Kılavuzu (15 sayfalar)
Sayfayı Yazdır
A
NEUVIDEO
RS-232 Commands
COMMAND
GET OUT A OSD BACKDROP COLOR 8
SET OUT A OSD LOGO DISPLAY N1 8
GET OUT A OSD LOGO DISPLAY 8
SET OUT A OSD LOGO VPOSITION N1
8
GET OUT A OSD LOGO VPOSITION 8
SET OUT A OSD LOGO HPOSITION N1
8
GET OUT A OSD LOGO HPOSITION 8
GET WEBGUI USERNAME 8
SET WEBGUI PASSWORD N1 8
GET WEBGUI PASSWORD 8
SET WEBGUI TIMEOUT N1 8
GET WEBGUI TIMEOUT 8
SET IP MODE N1 8
GET IP MODE 8
GET IPCONFIG 8
GET OUT A OSD FONT COLOR 8
SET IP ADDR N1 8
SET NETMASK N1 8
SET GATEWAY N1 8
SET TELNET TIMEOUT N1 8
GET TELNET TIMEOUT8
SET TELNET PORT N1 8
GET TELNET PORT 8
NOTE: Commands will not be executed unless followed by a carriage return. Commands are not case-sensitive.
DESCRIPTION & PARAMETERS
Show the current OSD background color.
Enable or disable the OSD graphical logo.
Available values for N1:
ON
[Enabled]
OFF
[Disabled]
Show the current state of the OSD graphical logo.
Set the vertical position of the OSD graphical logo.
N1 = 0 ~ 100
[Vertical position in %]
Show the current vertical position of the OSD graphical logo.
Set the horizontal position of the OSD graphical logo.
N1 = 0 ~ 100
[Horizontal position in %]
Show the current horizontal position of the OSD graphical logo.
Show the current WebGUI username.
Set the WebGUI login password to N1.
N1 = {password} [15 characters max]
Show the current WebGUI password.
Set the WebGUI inactivity timeout.
N1 = 0 ~ 6000
[Timeout in minutes]
Show the current WebGUI inactivity timeout value.
Set the IP address assignment mode.
Available values for N1:
0
[Static IP mode]
1
[DHCP mode]
Show the current IP mode.
Show the current IP configuration data.
Show the current OSD text color.
Set the static IP address.
N1 = X.X.X.X
[X = 0 ~ 255]
Set the static netmask address.
N1 = X.X.X.X
[X = 0 ~ 255]
Set the static gateway address.
N1 = X.X.X.X
[X = 0 ~ 255]
Set the Telnet inactivity timeout.
N1 = 0 ~ 6000
[Timeout in seconds]
Show the current Telnet inactivity timeout value.
Set the network port to use for Telnet communication.
N1 = 1 ~ 65535
[Telnet port]
Show the current Telnet port.
11
RS-232 & Telnet Commands