Kohler BELAY K-156T-LCP Kurulum Talimatları Kılavuzu - Sayfa 3
Banyo Armatürleri Kohler BELAY K-156T-LCP için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler BELAY K-156T-LCP 23 sayfaları.
Sayfayı Yazdır
PRODUCT INFORMATION
Electrical Requirements
· The installation must have one Residual Current
Device (RCD). The
ground shock hazards.
dedicated services for the bath.
Product Notices
WARNING: Unauthorized modification may
cause unsafe operation and poor
performance of the bath.
whirlpool pump or blower motor, or make other
modifications to the bath system, as this could
adversely affect the performance and safe
operation of the product. Kohler Co. shall not be
liable under its warranty or otherwise for
personal injury or damage caused by any such
unauthorized modification.
WARNING
:
The supply cord cannot be replaced.
If the cord is damaged the appliance should be
scrapped.
WARNING:
The appliance is not to be used by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction.
WARNING:
Children being supervised not to
play with the appliance.
WARNING:
Parts containing live parts, except
parts supplied with safety extra-low voltage not
exceeding 12 V, must be inaccessible to a
person in the bath.
WARNING:
Earthed appliances must be
permanently connected to fixed wiring.
WARNING
:
Parts incorporating electrical
components, except remote control devices,
must be located or fixed so that they cannot fall
into the bath.
WARNING
:
The appliance should be supplied
through a residual current device (RCD) with a
rated tripping current not exceeding 30 mA.
NOTICE: Keep the area around the blower motor clean
and free of sawdust, insulation, dirt, or other small
loose debris. Such material could plug the blower motor
air intake and reduce the air flow through the blower.
Connections and Service Access
·
Before installation, ensure proper access to the final
connections.
1397340-T01-A
RCD
's protect against line-to-
Use one 220V, 30A, 50Hz
Do not relocate the
·
(RCD)
50Hz
RCD
30mA
·
-3-
30mA
220 V
30A
12V
(RCD)