Kohler BodySpa K-1000 Kurulum Talimatları Kılavuzu - Sayfa 10
Banyo Armatürleri Kohler BodySpa K-1000 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler BodySpa K-1000 28 sayfaları. Tower custom hydro-massage system
Ayrıca Kohler BodySpa K-1000 için: Ev Sahibi El Kitabı (48 sayfalar)
Sayfayı Yazdır
9. DOOR ENCLOSURE PREPARATION
The BodySpa door enclosure is designed to fit only the
BodySpa footbath. Proper door enclosure assembly
depends upon installation of the footbath against square
and plumb studding. The stud supports must be within
3/8" of plumb.
IMPORTANT: Leave studs exposed. The door
enclosure wall jambs must be secured directly to the
double stud wall frame to achieve proper support of the
door enclosure. Expanding wall anchors in a hollow wall
will not provide adequate support for the door enclosure
assembly. Under no circumstances install the finished
wall material until instructed.
TE:
NO
The door enclosure components are identified
with removable labels. Refer to these labels to correctly
identify and install the enclosure components.
INSTALL THE ENCLOSURE
10.
A. INSTALL THE WALL JAMBS
Remove the wall jamb kit from the carton, and remove the
wall jambs. Leave the wall jamb protective tape in place.
Do not remove any other components from the carton at
this time.
Install one of the wall jambs by setting it against the
footbath locating pin, as shown. The wall jambs are not
interchangeable.
Use a level, and adjust the wall jamb to be exactly plumb.
Secure the wall jamb to the double stud framing and
furring strips with four 2" stainless steel flathead screws
(provided).
Repeat for the other wall jamb.
AB
116290-2-
2" Stainless
Steel Flathead
Screw
Footbath Locating Pin
10
Wall
Jamb
Level
Kohler Co., Kohler WI U.S.A.