Kohler K-1131 Kurulum Kılavuzu - Sayfa 13

Banyo Armatürleri Kohler K-1131 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Kohler K-1131 44 sayfaları. Bath whirlpool
Ayrıca Kohler K-1131 için: Ev Sahibi El Kitabı (32 sayfalar), Kurulum Kılavuzu (48 sayfalar), Kurulum Kılavuzu (44 sayfalar), Kurulum Kılavuzu (48 sayfalar)

Sayfayı Yazdır

Troubleshooting (cont.)

Symptoms

Whirlpool does not start

or stop.

2. Motor starts, not all jets

are functioning.

3. Whirlpool stops

automatically before 18

minutes.

4. Pump does not prime.

(Models with support

blocks only.)

5. Noisy operation.

6. Heater does not operate.

("H" models only)

Kohler Co.

Probable Causes

A. No power to motor.

B. Air hose is loose or disconnected.

C. Air hose is pinched or kinked.

D. Part(s) of the push button

assembly is/are damaged.

E. Push button has grease in the

bleed area.

Air hose is damaged.

G. Motor/pump does not work.

A. Jet is closed.

B. Jet not installed correctly.

C. Jets are blocked.

A. The GFCI or RCD trips.

B. Suction blocked.

C. Jets are blocked.

D. Motor overheated and protection

device activated.

A. Pump shimmed too high.

A. Pump banding straps have not

been cut. (Models with support

blocks only.)

B. Jet O-ring dislodged.

A. No power to heater.

B. Water temperature exceeds 104°F

(40°C).

C. Heater does not work.

Recommended Action

A. Check that the pump and heater

are plugged in and that the GFCI

or RCD is switched to the correct

position. Plug in or reset the

GFCI/RCD as needed.

B. Check that the hose is connected

at both the receiver/pump end

and to the air switch. Reconnect

if needed.

C. Adjust hose to clear the

pinched/kinked area. If the

tubing is pinched/kinked and

cannot be readjusted, or no

noticeable pinch/kink is

apparent, poke a small hole in

the tubing with a tack and try

the system again.

D. Replace the push button

assembly.

E. Disassemble the push button

assembly and wipe away any

excess grease. Reassemble the

button and retry the system.

Replace the air hose.

G. Rebuild or replace motor/pump.

A. Rotate jet trim ring

counterclockwise to open.

B. Reinstall jet; check for O-ring

damage.

C. Remove blockage.

A. Identify source of fault, and

correct.

B. Remove obstruction.

C. Remove blockage.

D. Check for blockage at motor

vents. Remove blockage and

allow motor to cool.

Check for suction blockage.

Remove blockage and allow

motor to cool.

Check for jet blockage. Remove

blockage and allow motor to

cool.

A. Lower pump support bracket.

A. Cut pump banding straps with

tin snips.

B. Remove jet, replace and lubricate

O-ring, and reinstall jet.

A. Reset the GFCI or RCD.

B. Allow water to cool and heater

will reengage.

C. Replace heater.

1011092-2-F