Kohler K-1144 Kurulum Kılavuzu - Sayfa 15

Banyo Armatürleri Kohler K-1144 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Kohler K-1144 48 sayfaları. Bath whirlpool
Ayrıca Kohler K-1144 için: Ev Sahibi El Kitabı (32 sayfalar), Kurulum Kılavuzu (44 sayfalar), Kurulum Kılavuzu (44 sayfalar), Kurulum Kılavuzu (48 sayfalar)

Sayfayı Yazdır

Troubleshooting Procedure (cont.)

Symptoms

2. Motor starts, not all jets are

functioning.

3. Whirlpool stops automatically

before 18 minutes.

Pump does not prime. (Models

with support blocks only.)

5. Noisy operation.

Heater does not operate. ("H"

models only)

Kohler Co.

Probable Causes

A. Jet is closed.

B. Jet not installed correctly.

C. Jets are blocked.

A. The GFCI or ELCB trips.

B. Suction blocked.

C. Jets are blocked.

D. Motor overheated and

protection device activated.

A. Pump shimmed too high.

A. Pump banding straps have not

been cut. (Models with support

blocks only.)

B. Jet O-ring dislodged.

A. No power to heater.

B. Water temperature exceeds

104° F (40° C).

C. Heater does not work.

Recommended Action

A. Rotate jet trim ring

counterclockwise to open.

B. Reinstall jet; check for O-ring

damage.

C. Remove blockage.

A. Identify source of fault, and

correct.

B. Remove obstruction.

C. Remove blockage.

D. Check for blockage at motor

vents. Remove blockage and

allow motor to cool.

Check for suction blockage.

Remove blockage and allow

motor to cool.

Check for jet blockage. Remove

blockage and allow motor to

cool.

A. Lower pump support bracket.

A. Cut pump banding straps with

tin snips.

B. Remove jet, replace and

lubricate O-ring, and reinstall

jet.

A. Reset the GFCI or ELCB.

B. Allow water to cool and heater

will reengage.

C. Replace heater.

1055820-2-A