Kohler K-1144 Kurulum Kılavuzu - Sayfa 15

Banyo Armatürleri Kohler K-1144 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Kohler K-1144 48 sayfaları. Bath whirlpool
Ayrıca Kohler K-1144 için: Ev Sahibi El Kitabı (32 sayfalar), Kurulum Kılavuzu (48 sayfalar), Kurulum Kılavuzu (44 sayfalar), Kurulum Kılavuzu (44 sayfalar)

Sayfayı Yazdır

Troubleshooting Procedure (cont.)

Symptoms

2. Motor starts, not all jets are

functioning.

3. Whirlpool stops

automatically before 18

minutes.

4. Pump does not prime.

(Models with support blocks

only.)

5. Noisy operation.

6. Heater does not operate.

("H" models only)

Kohler Co.

Probable Causes

D. Motor/pump does not work.

A. Jet is closed.

B. Jet not installed correctly.

C. Jets are blocked.

A. GFCI trips.

B. Suction blocked.

C. Jets are blocked.

D. Motor overheated and

protection device activated.

A. Pump shimmed too high.

A. Pump banding straps have

not been cut. (Models with

support blocks only.)

B. Jet O-ring dislodged.

A. No power to heater.

B. Water temperature exceeds

104° F (40° C).

C. Heater does not work.

Recommended Action

D. Rebuild or replace

motor/pump.

A. Rotate jet trim ring

counterclockwise to open.

B. Reinstall jet; check for O-ring

damage.

C. Remove blockage.

A. Identify source of fault, and

correct.

B. Remove obstruction.

C. Remove blockage.

D. Check for blockage at motor

vents. Remove blockage and

allow motor to cool.

Check for suction blockage.

Remove blockage and allow

motor to cool.

Check for jet blockage.

Remove blockage and allow

motor to cool.

A. Lower pump support

bracket.

A. Cut pump banding straps

with tin snips.

B. Remove jet, replace and

lubricate O-ring, and reinstall

jet.

A. Reset GFCI.

B. Allow water to cool and

heater will reengage.

C. Replace heater.

1010564-2-B