AEG L 87696 WD Kullanıcı Kılavuzu - Sayfa 22
Kurutucu AEG L 87696 WD için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG L 87696 WD 36 sayfaları. Washer dryer
Sayfayı Yazdır
22
www.aeg.com
9.16 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Start/Pause
button.
Press the button On/Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the button On/Off to activate
the appliance again.
10. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
10.1 Preparation to drying
1. Press button On/Off for some
seconds to activate the appliance
2. Load the laundry one item at a time.
3. Turn the programme dial to the
drying programme applicable for the
items to dry.
The display shows a minimum time value
and the following symbols:
The drying symbol comes on.
The anti-crease symbol comes on.
The drying time symbol comes on.
When drying a big amount
of laundry, to have good
drying performances, make
sure that the laundry itself is
not rolled up and that is
uniformly distributed in the
drum.
The display shows the end of the last
set programme.
Turn the programme knob to set a
new cycle.
If you set a programme or an
option that ends with water
in the drum, the AUTO
Stand-by function doesn't
deactivate the appliance to
remind you to drain the
water.
To have best performances
in drying when you wash the
laundry set a spin cycle at
the maximum speed allowed
for your type of items.
You can dry your laundry in two ways:
10.2 Automatic drying
1. Press button Drying Level repeatedly
until a black line appears under one
of the dryness level symbol:
Extra dry level
Cupboard dry level
Iron dry level
The drying time symbol goes off
The display shows a time value,
calculated on a default load size. If the
amount of your laundry is more or less
than the default size, the appliance
adjusts automatically the time value
during the cycle.
2. Press button Start/Pause to start the
programme. In the display: