Kohler K-1246 Kurulum Kılavuzu - Sayfa 10

Banyo Armatürleri Kohler K-1246 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Kohler K-1246 48 sayfaları. Bath whirlpool
Ayrıca Kohler K-1246 için: Ev Sahibi El Kitabı (32 sayfalar), Kaba İnşaat Kılavuzu (4 sayfalar), Kurulum Kılavuzu (48 sayfalar), Kaba İnşaat Kılavuzu (4 sayfalar), Kurulum Kılavuzu (44 sayfalar)

Measure, cut, and drill a piece of

1/2" exterior grade plywood 4"

(10.2cm) x 11-1/2" (29.2cm) for

the K-1226, or 4" (10.2cm) x

15-1/2" (39.4cm) for the K-1331

7. Install a Rim-Mounted Faucet

Measure and cut a piece of 1/2" exterior grade plywood 4" (10.2cm) x 11-1/2" (29.2cm) for the K-1226, or

4" (10.2cm) x 15-1/2" (39.4cm) for the K-1231.

The faucet should be located in the center of the ﬂat area of the rim. Refer to the faucet manufacturer's

instructions. Use a pencil to mark the faucet centerlines for drilling.

NOTE: The K-1226 will accept faucets with 4" centers, and the K-1231 will accept faucets with 4" or 6"

centers.

CAUTION: Risk of product damage. Position a thin piece of cardboard on the ﬁnished surface of the

whirlpool before clamping the plywood in place. Make sure the clamps do not make direct contact

with the ﬁnished surface of the whirlpool.

Set a thin piece of cardboard on the ﬁnished surface of the whirlpool rim. Position the plywood on the

bottom of the rim, and carefully clamp the plywood in place. Make sure the clamps are in contact with the

cardboard, not the ﬁnished surface of the whirlpool.

Carefully drill the faucet holes to the size required by the faucet manufacturer. Remove the clamps and

cardboard.

Install the faucet to the rim and plywood according to the faucet manufacturer's instructions.

Open the hot and cold water supplies, and check the supply connections for leakage.

Run water into the whirlpool, and check the drain connections for leakage.

1010564-2-B

Install the faucet to the rim

and plywood according to

the faucet manufacturer's

instructions

Kohler Co.