AEG LAVATHERM 59800 Kullanıcı Bilgileri - Sayfa 23
Kurutucu AEG LAVATHERM 59800 için çevrimiçi göz atın veya pdf Kullanıcı Bilgileri indirin. AEG LAVATHERM 59800 36 sayfaları. Aeg condenser dryer with heat pump
Ayrıca AEG LAVATHERM 59800 için: Kullanıcı Bilgileri (32 sayfalar)
Sayfayı Yazdır
Problem
Drying results unsatis-
factory.
Loading door does not
close.
When a button is
pressed, Err appears
in the multi-display.
Drum light does not
work.
PROGRAMME TIME
(LOOPTIJD) display
changes erratically or
stays unchanged for a
long time.
Programme inactive,
EMPTY WATER (RESER-
VOIR) display illumi-
nated.
Drying cycle ends
shortly after pro-
gramme starts. END
(EINDE) display illumi-
nated.
Possible cause
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Overloading of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Programme selector in OFF
(UIT) position.
Defective light bulb.
Programme time is correct-
ed automatically depending
on type and volume of
laundry and level of damp-
ness.
Condensate tank is full.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Remedy
Select a different programme
the next time you dry (see
"Overview of programmes"
section).
Clean lint filters.
Clean fluff filter.
Observe recommended load-
ing volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs.
Make an adjustment using the
INTENSITY (RESTVOCHT) func-
tion (see chapter "Drying, Se-
lecting additional functions").
Install fine strainer and/or
snap large mesh filter into
place.
Turn the programme knob to
OFF (UIT). Set the programme
again.
Turn programme selector to
LIGHT (VERLICHTING) or to any
programme.
Replace light bulb (see next
section).
Automatic process; this is not
a machine fault.
Empty condensate tank, then
start programme with START/
PAUSE (START/PAUZE) button.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY [INTENSIEFDROOG]
instead of STORAGE DRY
[KASTDROOG]).
23