AEG LAVATHERM 59840 Kullanıcı Kılavuzu - Sayfa 37

Kurutucu AEG LAVATHERM 59840 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG LAVATHERM 59840 48 sayfaları. Condenser dryer with heat pump

Sayfayı Yazdır

Permanent connection

In the case of permanent connection it is necessary that you install a double pole

switch between the appliance and the electricity supply (mains), with a minimum

gap of 3mm between the switch contacts and of a type suitable for the required

load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

Changing door stop

WARNING!

The door stop may only be changed by a specialist. If necessary, please contact our

after-sales service or your specialist dealer.

WARNING!

Before changing the door stop, disconnect the mains plug.

Open loading door.

Unscrew hinge A from the front of the

machine and take off the loading door.

Remove cover plates B and C. To do this,

insert a thin screwdriver into the slots as

shown in the illustration, press down-

wards slightly and pry out the cover

plates.

Use an appropriate tool and exert pres-

sure to unfasten locking block D from

the snap-on fixture, take out and re-in-

sert on the other side having rotated the

block through 180°.

Unscrew hinge A from the loading door,

rotate through 180°, re-insert on the

opposite side and screw down.

Re-insert cover plates B and C on the opposite site having first rotated them

through 180°.

Installation