AEG LAVATHERM 76484EIH Kullanıcı Kılavuzu - Sayfa 15

Kurutucu AEG LAVATHERM 76484EIH için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG LAVATHERM 76484EIH 28 sayfaları. Aeg tumble dryer

Sayfayı Yazdır

HINTS AND TIPS

ECOLOGICAL HINTS

• Do not use fabric softener to wash and

then dry. In the tumble dryer laundry

becomes soft automatically.

• Use the condensate as distilled water,

e.g. for steam ironing. If it is necessary

clean the condensate before (e.g. with

a coffee filter) to remove possible small

pieces of fluff.

• Always keep the airflow slots on the

bottom of the appliance clear.

• Use the load volumes which are speci-

fied in the programmes chapter.

• Make sure that is good airflow in the

appliance installation position.

• Clean the primary filter after each dry-

ing cycle.

• Clean the heat exchanger filters when

the applicable indicator comes into the

view on the control panel.

• Spin good the laundry before drying.

WATER HARDNESS AND

CONDUCTIVITY

Water hardness can be different for differ-

ent locations. Water hardness has an ef-

fect on the water conductivity and the op-

eration of the conductivity sensor in the

appliance. If you know the value of the

water conductivity you can adjust the sen-

sor to dry with the better results.

To change the sensor conductivity:

Turn the programme dial to available

programme.

Push at the same time the Dry Plus

and the Anticrease buttons. Hold

down until one of the symbols go into

view on the display:

–

300-600 μS/cm

–

Push the Start Pause button again

and again until you set necessary lev-

el.

low conductivity <300 μS/

moderate conductivity

high conductivity >600 μS/

To memorise the setting push at the

same time the Dry Plus and the Anti-

crease buttons.

WATER CONTAINER FULL —

INDICATION

By default the indication LED is always on.

It comes into the view at the end of the

cycle or when the water container is full.

When you use an external equipment to

drain the container, the LED can be off.

To activate or deactivate the indication:

Turn the programme dial to available

programme.

Push at the same time the Dry Plus

and Buzzer buttons and hold down

until you see the correct setting:

– the LED is off and the symbol

goes into the view - The

LED is permanently off

– the LED is on and the symbol

goes into the view - The

LED is activated

ENGLISH