AEG LAVATHERM 96695IH Kullanıcı Kılavuzu - Sayfa 18
Kurutucu AEG LAVATHERM 96695IH için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG LAVATHERM 96695IH 28 sayfaları. Dryer aeg lavatherm 96695ih
Sayfayı Yazdır18
www.aeg.com
S e n s i D r y
Anti-
Dry Plus
crease
If the configuration is saved you see the
message on the display.
To use your own configuration:
3. Turn on the appliance.
4. Touch the Memory 1 or Memory 2
field.
9.9 Starting a programme
To start the programme:
S e n s i D r y
Anti-
Dry Plus
crease
Touch the Start/Pause field.
The appliance starts and the LED above
the touch field does not flash but is
stable.
9.10 Programme change
To change a programme:
10. HINTS AND TIPS
10.1 Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
Spun at
Delay
Buzzer
Time Dry
Start
RPM
Spun at
Delay
Buzzer
Time Dry
Start
RPM
1. Push the On/Off button to turn off
the appliance.
2. Push again the On/Off button to turn
Extra Silent
on the appliance.
Memory 1
3. Set a new programme.
Memory 2
9.11 Programme end
Start/Pause
If the drying cycle is completed, the
symbol
Buzzer option is on, the acoustic signal
sounds intermittently for 1 minute.
Extra Silent
Memory 1
To remove the laundry:
Memory 2
1. Push the On/Off button for 2
Start/Pause
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Touch at the same time and hold
down the Dry Plus and Spun at RPM
option fields.
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
flashes on the display. If the
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.