Kohler STRAYT 99166T-C4DPW Kurulum Talimatları - Sayfa 2
Banyo Armatürleri Kohler STRAYT 99166T-C4DPW için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Kohler STRAYT 99166T-C4DPW 2 sayfaları. Floor-mount bath & shower faucet
Sayfayı Yazdır
INSTALLATION
How to Install the Faucet
Shut off water supply. Cut away the extending part of the base
protector(1) in accordance with the tile surface. Remove plug(2) from
base. Remove protector(3) from the faucet.
Slide up escutcheon kit(4). Install the faucet. NOTE: Keep the faucet
vertical to base, to avoid damaging the o-ring on the bottom.
Keep the spout pointing to tub. Fix the faucet to the base with screws(5)
and washers(6) through flange(7). Tighten the screws with hex
wrench(8).
Slide down the escutcheon kit, make sure it against the finished floor.
How to Install the Handshower
Remove the protector from diverter kit(9).
If needed, install the restrictor(10) into the inlet of the handshower(11)
according to installation instruction. Connect hose(12) to diverter kit and
handshower with washers(13). Tighten all the connections.
Hang the handshower on the bracket(14) of the faucet.
How to Operate the Handshower
Press the buttons of the handshower to change the water flow.
How to Maintain the Handshower
Any debris or mineral build-up may cause the flow stream to become
distorted or reduce the flow rate. To remove the debris or mineral build-up,
run water through the handshower, firmly press or rub your finger back
and forth across the rubber nozzles.
1338598-2A-B
4
8
5
6
7
3
1
2
14
11
10
13
9
12
Katalyst Air
Intense Massage
2
Remove and clean the screen washer.
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight. Ensure that the handle is in the off
position.
Turn on the main water supply, and check for leaks. Repair as needed.
Remove the aerator(15) by key(16). Remove the handshower(11). Turn
on faucet handle. Run hot and cold water through spout for about one
minute to remove any debris. Check for leaks at this time. Remove any
debris. Shut off the faucet. Reinstall the aerator and handshower.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1338598-2A-B
11
15
16
3